March Chemical Pumps For Sodium Hydroxide

Seeking a pump for the chemical Sodium Hydroxide, March Pumps has many choices!  From 5 GPM to 200 GPM, March Pumps has a pump for Sodium Hydroxide for the application. 

If pumping the chemical Sodium Hydroxide at room temperature, it is recommended to go with a centrifugal  sealless magnetic drive chemical pump made up of Ryton and/or Polypropylene Plastic, Encapsulated Impeller, Teflon O-Ring, and either a Carbon or Ryton/Teflon/Carbon combination Bushing. 

The chemical Sodium Hydroxide can also be heavy depending on the concentration and temperature.  If the specific gravity is more than 1.1, a trimmed impeller is absolutely necessary to prevent decoupling or overloading the motor. 

The following chemical pumps are a good place to start looking at when pumping the chemical Sodium Hydroxide:

TE-5C-MD with special Teflon O-Ring and possible trim for the chemical Sodium Hydroxide

TE-5.5C-MD with special Teflon O-Ring and possible trim for the chemical Sodium Hydroxide

TE-6T-MD with special Teflon O-Ring and possible trim for the chemical Sodium Hydroxide

TE-7R-MD with special Teflon O-Ring and possible trim for the chemical Sodium Hydroxide

TE-7.5P-MD with special Teflon O-Ring and trim for the chemical Sodium Hydroxide

TE-8C-MD with special Teflon O-Ring and possible trim for the chemical Sodium Hydroxide

320-CP-MD with special Teflon O-Ring and possible trim for the chemical Sodium Hydroxide 

Higher concentrations and higher temperatures of the chemical Sodium Hydroxide, together or by themselves, may make the pumps listed above unsuitable.  It is highly recommended, regardless of the temperature or concentration, that you contact a local distributor or March Manufacturing direct to review your application before ordering a pump.      

Listing of March Pump Sodium Hydroxide Distributors  

Warranty 

March Manufacturing Inc. Warranty and Warranty Registration                               

Search Our Pumps Distributor Map