2CP-MD Mag Drive Pump
|Max Flow||5 GPM||18.9 LPM||4.9 GPM||18.5 LPM|
|Max Head||13 FT||4 M||8.9 FT||2.7 M|
|Power||.02 HP||.015 KW||.018 HP||.014 KW|
|Electrical||115V 50/60HZ or 230V 50/60HZ|
|Type||Centrifugal Mag Drive|
|Inlet||3/8"FPT & 3/4"MPT|
|Wet End||Polypropylene (Front and Rear Housing, Impeller), Viton (O-Ring), Stainless Steel (Shaft), Ceramic (Thrust Washer), Ceramic Magnet|
|When submerged, the following is also in contact with the solution||Epoxy, Buna N, Cord|
O-Ring: Buna N, Viton, or Ethylene Propylene
Shaft: Ceramic or 316 Stainless Steel
Impeller: Polypropylene or Delrin
March Pump's industrial 2CP-MD is an American submersible seal-less centrifugal magnetic drive pump. It is capable of generating a maximum flow of 5 gallons per minute at 1 foot, and its maximum head is 13 Feet (or around 5.5PSI). The 2CP-MD pump must be used submerged. The standard wet end (the materials that come into contact with the solution) is composed of Polypropylene, Viton, Stainless Steel, Ceramic, and Ceramic Magnet. When submerged, Epoxy, Buna N, and the Cord are also in contact with the solution. The inlet connection is 3/8 inch female pipe thread and 3/4 inch male pipe thread, and the outlet is 1/4 inch male pipe thread. The standard motor is a 1 Phase 115V or 230V 0.02 Horsepower motor, which can be run on either 50 or 60 hertz (there are performance differences between the hertz options). The maximum internal pressure the pump can tolerate is 50PSI, and the maximum liquid temperature is 130 Fahrenheit or 54 Celsius. The March 2CP-MD centrifugal magnetic drive pump is capable of handling fresh water, salt water, and mild chemicals. To determine if the March 2CP-MD is suitable for your application, please contact March Pump.
Perfect for Applications Including
The most common application for the 2CP-MD Magnetic Drive Pump is for marine air conditioning and fountains.
Great for Chemicals Including
The 2CP-MD has pumped Fresh Water and Salt Water. The 2CP-MD may have been modified to handle these chemicals. Please contact March Pump to review your application before using the 2CP-MD for any of the above listed chemicals.